For Drivers

• Please visually check the surrounding environment as there are areas that cannot be seen from the driver's seat.
• The driver's seat is high, so please grab the handrail at the top.It is smooth if the front passenger gets in first, and you can also get in from the rear space.
• For the ETC, please set it before driving. The vehicle is provided with full fuel while checking in. Please return the vehicle with the full fuel while checking out.
• Please use the lever directly below the seat to adjust the seat position.Please adjust the mirror before starting to drive.
• Please be careful not to forget to fasten your seat belt.To start the engine, turn the key with the brake depressed.The hand brake is located on the left side of the driver's seat.When going up a hill, it is better to put the car in low gear to make the ascent smoother.
• Also, when going downhill, putting the engine in low gear will allow you to decelerate safely by using the engine brake.
• Don’t leave the car key in the key lock. Take the key out of the vehicle when the vehicle is parked. If the key is in ACC mode, the vehicle’s engine will shut down.
• Turn off the front light and air conditioning while the engine is off.
• While driving, the Ecoflow battery should be on the “Engine charge,” and while it’s parked, the battery should be on the “Solar charge”. This would allow the battery to be full. The EcoFlow battery supplies the power for 2 extension cords and a roof light.

In case of the engine shutdown, follow the following procedures.

• Find the jumper which is located on the left side’s first box behind the back seat.
• Unlock two hooks under the passenger seat and open the engine compartment.
• First, connect the red jumper cable to the red connection outlet of the engine , followed by the black cable to the black connection outlet of the engine.
• Set the jumper voltage to 12V.
• Long press “Boost” until the light turns green.
• Start the engine. Once the engine is running, disconnect the jumper.

For Passengers

• When changing from a tatami to a table, it is smoother if you hold on to the string attached to the tatami.
• When using the expressway, please use the seatbelt by changing it into a table, as it is required to wear a seatbelt.
• When changing the seat from a table to a tatami mat, please place the seatbelt's joint in the lower part of the seat.
• When sleeping, you may use the air mats located under the seats.When using the optional sleeping bag, please be sure to use the inner sheet of the sleeping bag.
• Electricity outlets are located at both sides of the first and third tatami mats from the passenger entrance. There are several USB outlets located near the curtains in the left rear of the car. Please use them as well.
• Please use the PHILIPS remote control to adjust the brightness. Press ｜ to change the mode and ○ to turn it off.The speakers can be operated with the BOSE remote control; press and hold the Bluetooth symbol and the blue light on the main unit will flash to enable pairing.
• The heater switch is located in the trunk compartment. It can also be operated from inside the car by opening the door. .
• Please remember to turn off the inverter switch in the trunk compartment when you go out of the car

In case of an accident, contact the officer working on-site either through e-mail or phone.

To connect with the Japanese Hotline number, call 0120-256-110 (Sompo Japan Insurance Accident). They are available 24/7.

Steps to follow while contacting Sompo Japan in case the Japanese language is not understood.

• The automatic voice messages are in Japanese only. Hold the line without pressing any button and you will be connected to the Japanese-speaking operator.
• Request the operator to connect to an interpreter (tsu-yakusha / chu-yakusha). The company will arrange a three-way call between caller, operator and the interpreter.